Lenco L-175 Manuel d'utilisateur télécharger pdf (Page 9)

Maintenance

TO REPLACE THE STYLUS (FIG.A)

- Put the rest (11) clip on the pick-up arm.

- Remove the protective cap from the stylus.

- Pull the stylus in the direction of arrow (A) and remove it.

- Put in the new stylus following the reverse procedure.

- Replace the protective cap on the stylus.

TO DISASSEMBLE THE CARTRIDGE (FIG.B)

- Put the rest clip into the pick-up arm.

- Remove the stylus (see section above).

- Release the pick-up head, push the cartridge in the direction of

arrow.

- Disconnect the four link wires at the level of the pick-up head.

TO INSTALL NEW CARTRIDGE

- Connect the four link wires as shown in figure.

- Push the cartridge into head shell

- Re-position the stylus

- Replace the protective cap on the stylus.

Important Recommendations

We advise you to clean your records using a rag impregnate with an

antistatic product for maximum enjoyment of your records and also to

make them last.

We would also point out that for the same reason your stylus should be

replaced periodically (approximately every 250 hours)

Dust the stylus from time to time using a very soft brush dipped in alcohol

(brushing from back to front of the cartridge)

WHEN TRANSPORTING YOUR RECORD PLAYER DO NOT FORGET

TO:

 Replace the protective cap on the stylus.

 Put the rest clip into the pick-up arm.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 28 29

Pas de commentaire

Lenco L-175 Manuel d'utilisateur Page 9